Multifunction devices electronic
Codix 544
|
|
Multifunction counter – up to 3 functions in one device.
The Codix 544 is a voltage-powered multifunction counter with3 functions in one device: pulse, position, frequency and speed display, timer and short time meter for fast and slow count pulses. With 6-digit LED display for NPN, PNP input signals.Mechanical | |
---|---|
Model | Multifunction device electronic |
Functions |
Pulse counter Frequency display Position displays without limit values Tachometer without limi valuets Hour meters / timers Short-time meter |
Dimension 1 |
96 x 48 mm | 92 x 45 mm |
Protection level |
IP65 |
Working temperature | -20 °C ... +65 °C |
Weight | 150 g |
Reset |
electronic |
(1) Front panel size | Panel cut-out
Electrical | |
---|---|
Power supply |
100...240 (± 10%) V AC 10...30 V DC |
Signal input |
NPN PNP |
Powerful
- Fast count and frequency input – input frequency max. 60 kHz
- Robust housing – IP65 protected
- Very bright LED display, 14 mm high, 6 digits
- Very accurate precise frequency measurement principle (HRA-High Rate Accuracy System) Frequencies up to 38 Hz are calculated using time-interval (period duration) measurement. Frequencies > 38 Hz are calculated using a special time base (gate time) measurement. A very high accuracy of < 0.1% is achieved, even with very short gate times. The resulting measurement is available after a max. of 50 ms.
- Short start-up time – detects input pulses just 16 msec after being switched on => no pulses are lost with a simultaneous motor start-up
- Large keys – can also be operated when wearing gloves
- Programming:
- Simple uniform menu-driven programming and operation
- Possible to enter the programming also during operation with a confirmation prompt
- Individually programmable scaling: multiplication and division factor (0.0001…99.9999), to display corresponding engineering units, e.g. position in 1/10 mm and speed in RPM
- 4 different count input modes: 2-channel count input for detecting count direction, difference or adding mode, quadrature with x1, x2 or x4 evaluation
- Frequency measurement: display in 1/min or 1/sec
- Time counting: pulse width or time interval measurement in hours, minutes or seconds, as well as real-time display
- AC or DC power supply
- Inputs: as an alternative to the HTL inputs, devices are available with a 5 V DC input level, for use as parallel displays to PLCs
- Optional output: zero signal for position and count, zero speed monitoring, 1 Hz clock pulse for active time measurement